Chapter 6: Allison Hamann, Chris Barile

Victim Cache

Victim caches were first proposed by Norman P. Jouppi in 1990. Victim caching implements a small, fully-associative cache between direct-mapped L1 memory and the next level of memory. The cache allows lines evicted from the L1 cache a “second-chance” by loading them into the victim cache. Victim caches decrease the overall conflict miss rate (Jouppi).

Direct-mapped caches can especially benefit from victim caching due to their large miss rates. Victim caching allows direct-mapped caches to still be used in order to take advantage of their speed while decreasing the miss rate to an even lower rate than the miss rate found in set-associative caches (Jouppi).

Handling Misses

The proposed victim cache is fully-associative and lies between the L1 memory and the next level of memory. While Jouppi proposed a victim cache with 1 to 5 entries, Naz et al. proposed that the victim caches should be 4 to 16 cache lines.<ref>http://ieeexplore.ieee.org/xpl/freeabs_all.jsp?arnumber=134547</ref><ref>http://dl.acm.org/citation.cfm?id=1101876</ref> Regardless of the size, when a miss occurs in the L1 cache, the victim cache is then scanned for the wanted line. If a miss occurs in both the L1 and victim cache, the needed line is then pulled from the next level, and the line evicted from the L1 cache is then placed in the victim cache. If a miss occurs in the L1 cache but hits in the victim cache, the two lines are swapped between the two caches. Thus, this eliminates the majority of conflict misses that occur due to temporal locality.

Sector Cache

Sector cache is where the cache is divided into sectors. These sectors correspond to a logical sector on the main storage device. When sectors are needed, they are not loaded into cache all at once, but in smaller pieces known as subsectors. Subsectors are similar to the lines in a direct mapped cache.

When a process requests data from a disk sector that is not in the cache, a cache sector is assigned to the sector on the main storage device where the requested data is stored. Then the subsector where the data is located is loaded into the cache. The subsector's validity bit is then set to reflect that it has been loaded from the main storage. When data from other subsectors within a loaded sector are requested, the system loads those subsectors into the cache sector and sets their validity bits. Sectors are not removed from the cache until the system needs to reclaim the space to process another request.

One reason for this approach is that programs are generally organized in contiguous blocks on disk, . Another is that data is first looked up by sector, and then by subsector, which means that it can be found much quicker, and the hardware to do the simultaneous comparison of tags is less expensive.

References

<references />